 |
| News List |
|
|
 |
|
| Contact Us |
 |
Add:Kanmen Science and Technology Zone,Yuhuan
Tel:+86-576-8715 0150
Fax:+86-576-8755 32222
E-mail:jdeyxc@sllgbrake.com
slbrake@126.com |
|
|
|
|
 |
 |
News Details |
 |
| Car stalling is what causes?
|
| Published:2014.05.08 News source:Yuhuan County Shuangliang Automotive Parts Co., Ltd. Views: |
| |
According ShuangLiang brake booster is understood the car stalled process and reasons:
An oil passage problem: automobile engine may cause problems or passage, usually for car, the engine itself, the problem is less likely, because the passage of most of the problems. If the quality of gasoline will cause problems such failure. It could be you add the oil, product quality tests, plastic fat too much, the oil passage blocked, caused by poor fuel.
2 engine problems: damage to the engine idle speed motor line or idling motor; engine electronic control unit (ECU) in the idle speed control module in question; engine idling motor has seizure; engine speed sensor is defective or dirty.
3. Other issues: Wire idling motor cortex some frayed; idle air hole dirty;; camshaft position sensor or crankshaft position sensor is defective; intake manifold leak; brake vacuum booster vacuum leaking; brake vacuum Booster film breakage.
According ShuangLiang brake booster learned that the car flameout approach:
1, when the vibrations may be the cause of failure, you can jiggle the vertical and horizontal directions, or jiggle the wiring connector, equipped with a finger tap sensor parts, check whether the flame, but beat the relay can not be forced, otherwise it would Parts damaged sensor.
2, if a fault occurs only in the hot car, it may be related to the heat caused parts or sensors, heating tools available hair dryer or similar heat may cause a malfunction of components or sensors to check whether there is a fault. It must be noted that the heating temperature not higher than 60 鈩� and not directly heated computer parts.
3, when some of the fault is in the rain or high humidity to produce, you can spray water on the vehicle, check whether the fault occurs. But it should be careful not to spray water directly on the engine electronic control parts or electronic components, but should spray in front of the radiator indirect change of humidity and temperature;
4, to a high standard using a qualified fuel quality, and thoroughly wash the oil line again, including fuel injectors, throttle, fuel tank, etc.
In addition, periodic maintenance is also crucial car, always check the oil and the circuit is smooth, in addition to improve driving techniques can effectively reduce the car is turned off.
|
| |
|
 |
|
